21
February 19, 2020
7037-801B
Begin installing the ARS System:
1.
Remove leg mount brackets packaged inside of firebox
and discard.
2.
Remove the 2 bricks in the front most part of the firebox
(Figure 21.1)
.
3.
Lay appliance on its back on a protective pad or pallet
(Figure 21.2)
.
4.
Remove heat shield by loosening the four bolts using
3/8 open end wrench
(Figure 21.2)
.
5. Remove 8 nuts that hold the cover plate on using a
7/16 socket wrench; discard cover plate
(Figure 21.2)
.
Loosen
X4
Remove
X8
Remove
& discard
Gasket
Knock out
& discard
X
5
3
4
4
6
NOTE:
The Ash Removal System, must be installed first
before installing the pedestal.
A. Pedestal Assembly & ARS Installation
Slot to slide rod of Ash
Door Assembly through
8 threaded
studs
Ash Door
Assembly
6.
Remove knock out from bottom of firebox by using a
hammer
(Figure 21.2)
.
7.
Install ash door assembly by sliding the rod at an angle
into the slot on the left side
(Figure 21.3)
.
8. Slide the ash door over the 8 screws protruding from
the bottom of the appliance. Secure with nuts and
washers using 7/16 socket wrench (
Figure 21.3)
.
9.
Install ARS latch by sliding latch assembly over 2
threaded studs protruding from the bottom on the left
hand side of the appliance. Secure by using two nuts
use 7/16 socket wrench
(Figure 21.3)
.
10.
11.
Using two bolts and two flange nuts to secure ARS
channel using 3/8 open end wrench and 7/16 socket
wrench
Fire Risk. Do NOT operate before fully
assembling components.
Burning your appliance without a pedestal or
leg kit attached:
• Will void your warranty.
• May result in property damage or
personal injury.
WARNING
5
Appliance Set-Up
2
2
Remove 2 bricks for
installation and then re-install
Remove
and discard
Figure 21.3
Figure 21.1
Figure 21.2
CHECK GASKET!
• Verify that the gasket is present and that the glossy
side is away from firebox bottom.
• It is important that the gasket is put in correctly for
sealing capabilities.
WARNING!
