4100-I ACT Wood Insert
Page 28
April 19, 2010
R
250-7201F
• Use only glass specified in manual.
• DO NOT REPLACE with any other material.
Glass breakage will occur.
WARNING
Fire Risk.
Injury Risk.
Handle glass with care.
• Inspect the gasket to ensure it is
undamaged.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
& door assembly removed.
WARNING
Glass
Assembly
• Do NOT operate with glass cracked, broken or scratched.
Glass Replacement Instructions
Replace with 5mm ceramic glass only
1. Remove door from insert and lay on a padded flat sur-
face.
2. Remove glass retainer screws using a Phillips screw-
driver.
. Lift glass out of the door frame and/or side frames.
4. Lay new glass with fiberglass tape around it into door
frame and/or side frames.
5. Place glass retainers over the fiberglass tape on the
edges of the glass and re-install screws. Be sure glass is
centered in the opening (i.e. same space top and bottom,
left and right).
6. Tighten screws enough to hold frame and glass in place.
7. Check again for centering of glass in door and/or side
frames and give all screws a final tightening.
Handle glass assembly with care.
When cleaning glass:
• Avoid striking, scratching or
slamming glass.
•
Do NOT clean glass when hot.
CAUTION
•
Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white film.
• Use commercial oven cleaner on heavier deposits.
• Remove all residue of oven cleaner or will permanently
stain glass on next firing.
• Refer to maintenance instructions.
Glass
Assembly
