Page 17
April 19, 2010
4100-I ACT Wood Insert
250-7201F
R
Zero Clearance Adjustable Trim Support
Two sizes: 9”d x 45”w and 12”d x 50”w, both 2” to 10” Height Adjustment
Included in Kit:
(1) trim top, (1) trim front, (2) trim sides,
double-sided tape (already installed)
Tools Needed:
Phillips Head screwdriver, sheet metal
shears, measuring tape, gloves
1. The 10 screws on each set of scissors will already be
loose when shipped.
Figure 17.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips Head screwdriver.
Figure
17.2.
. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from
top
of trim’s edge, not bottom. This edge will
be sharp; wear gloves to prevent injury to your hands.
Figure 17.2.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims
to scissors has a powerful bonding adhesive. Adjust
-
ments are extremely difficult once trim has adhered to
tape. Do a dry run first without removing paper from
tape.
6. Place cut edge of trim under top lip and into position
on scissors. Place side pieces on first and then front
piece. The front piece overlaps side pieces.
NOTE
:
The trim in the Flush mount Kit is one piece
.
7. Once you are satisfied with the positioning, remove
trim and set aside.
8. Remove the paper from double-sided tape that is
to accept trim side. Align side and then press hard
against tape to secure side piece. Repeat for other
side. Install front trim piece last.
NOTE
:
/8 inch (9.5mm) thick tile or like material can
be cut to size and fit under lip of top trim edge for a
decorative touch.
Figure 17.3.
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Decorative tile
may be installed
INSTALL FRONT TRIM LAST.
CORNERS OvERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGHT
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Figure 17.1
Figure 17.2
Figure 17.3
