4100-I ACT Wood Insert
Page 16
April 19, 2010
R
250-7201F
Leveling Bolts
Sheet Metal Shims
Place under leveling bolts
and slide insert into place
Leveling Bolt
Reach between side of insert and outer skin
cut-out view
This product shipped with two leveling bolts, and two sheet
metal guides for ease in sliding the insert into place when
using the leveling bolts. Not all installations will require the
use of the leveling bolts. The sheet metal guides are used
only when the leveling bolts are necessary. Discard if not
needed.
Leveling Bolts And Sheet Metal Shims
Sheet Metal Guides
Slide each guide under the insert on each side placing
them directly under leveling bolts. If they are not directly
under the bolts, the bolts may hang up on uneven material
when sliding the insert into place.
Figure 16.1.
Adjusting The Leveling Bolts
It is best to use a 1/2 inch (12.7mm) socket wrench with an
extended handle for ease in adjusting bolts to the desired
level. The bolts will adjust from 0 to 2 inches (0 - 51mm).
You can also reach in and adjust the bolts by hand, although
space is limited.
Figure 16.2.
Figure 16.1
Figure 16.2
Door Handle Assembly
Door Latch Adjustment
Adjustment Bolts
Securing
Scre
w
It is important the door gasket has a proper seal. As the
gasket compresses or “seats” during use, it may become
necessary to adjust or tighten the door latch.
1. Loosen securing screw (do not remove).
2. Turn adjustment bolts as need for adjustment (in or out)
using 7/16” end wrench.
. Tighten securing screw to hold adjusted position in
place.
Nut 1/4-20
Washer
Door Latch Bracket
Washer, 5/8 x 1/4
Hook Door Latch
Door Handle
Fiber Handle
Figure 16.3
Figure 16.4
