12
AUG 2020
INSTALL GUIDE
3
LIFTING KIT
DS-200iQ / DS-600iQ
REV 00
3. After the lugs have been set to the required location, they must be secured
with the supplied M6x45 screw (E2803A) as shown in Figure 3.3.
The screw is used simply as a location pin to prevent sideways
movement of the lugs, and does not screw into place.
QDT-RND-OPS-00000284-A-00
Figure 3.3 – Location pin security screw
4. Once the beam and the screw (location pin) has been correctly located,
tighten the lockscrews on each end as shown in Figure 3.4 to secure the beam
in place.
QDT-RND-OPS-00000285-A-00
Figure 3.4 – Securing the lockscrews
Summary of Contents for DS-200iQ
