+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
113
Switch(Config-Ethernet1/1)# dot1q-tunnel enable
Switch(Config-Ethernet1/1)# exit
Switch(Config)#interface ethernet 1/10
Switch(Config-Ethernet1/10)#switchport mode trunk
Switch(Config-Ethernet1/10)#exit
Switch(config)#dot1q-tunnel tpid 0x9100
Switch(Config)#
PE2:
Switch(config)#vlan 3
Switch(Config-Vlan3)#switchport interface ethernet 1/1
Switch(Config-Vlan3)#exit
Switch(Config)#interface ethernet 1/1
Switch(Config-Ethernet1/1)# dot1q-tunnel enable
Switch(Config-Ethernet1/1)# exit
Switch(Config)#interface ethernet 1/10
Switch(Config-Ethernet1/10)#switchport mode trunk
Switch(Config-Ethernet1/10)#exit
Switch(config)#dot1q-tunnel tpid 0x9100
Switch(Config)#
16.2.4 Dot1q-tunnel Troubleshooting
Enabling dot1q-tunnel on Trunk port will make the tag of the data packet unpredictable which is
not required in the application. So it is not recommended to enable dot1q-tunnel on Trunk port.
Enabled with STP/MSTP is not supported.
Enabled with PVLAN is not supported.
16.3 Selective QinQ Configuration
16.3.1 Introduction to Selective QinQ
Selective QinQ is an enhanced application for dot1q tunnel function. It is able to tag packets
(they are received by the same port) with different outer VLAN tags based on different inner
VLAN tags according to user’s requirement, so it is able to implement that packets of different
types are assigned to different VLAN by selecting different transmission path.
16.3.2 Selective QinQ Configuration
Selective QinQ Configuration Task List:
Summary of Contents for QSW-2800 series
Page 189: ...7 495 797 3311 www qtech ru 18 1 175...
