Qlogic SANbox 5802V, Interface Manual, Page: 109 / 412

7 – Zoning Configuration
Configuring the Zoning Database
59263-01 A 7-11
A
To modify the zoning configuration, you must open an Admin session with the
Admin Start command. An Admin session prevents other accounts from making
changes at the same time through Telnet, QuickTools, Enterprise Fabric Suite
2007, or another management application. You must also open a Config Edit
session with the
Config Edit command and indicate which configuration you want
to modify. If you do not specify a configuration name, the active configuration is
assumed.
The Config Edit session provides access to the Set Config Zoning command as
shown in the following example:
SANbox #> admin start
SANbox (admin) #> config edit
The config named default is being edited.
SANbox (admin-config) #> set config zoning
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list press 'q'
or 'Q' and the ENTER key to do so.
MergeAutoSave (True / False) [True ]
DefaultZone (Allow / Deny) [Allow ]
DiscardInactive (True / False) [False]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
SANbox (admin-config)#> config save
SANbox (admin)#> config activate
SANbox (admin)#> admin end