Qlogic QConvergeConsole CLI 2400 Series, User Manual

Page: 125 / 366

6–iSCSI Noninteractive Commands
-nh (Configure iSCSI Settings)
SN0054667-00 C 6-19
To set everything automatically, issue the following commmand:
-netconf6 0 -IPLLA -IPR01A -IPRRA
To disable the IPv4 network, issue the following command:
-netconf6 0 -DISN4
To disable the IPv4 and IPv6 networks, issue the following command:
-netconf6 0 -DISN4 DISN6
-nh
(Configure iSCSI Settings)
To set the adapter-level parameters for multiport adapters, issue the
-nh
command as follows:
-nh <hba_port_inst> < Config name | Config alias > < Value >
[<< Config name | Config alias >> < Value >
…
]
The valid parameters and their values are shown in Table 6-3 .
-pa
(Add a Target)
To add persistent targets, issue the
-pa
command as follows:
-pa < hba_port_inst > < IP Address > [-PORT port number ] [-INAME iSCSI
Name ]
If you do not specify a port number
[-PORT port number]
, QConvergeConsole
CLI uses the default number 3260. If you do not specify an iSCSI name
[-INAME
iSCSI Name ]
, QConvergeConsole CLI uses the default value, an empty string.
-pad
To view all targets for a port, issue the
-pad
command as follows:
-pad < hba_port_inst >
-pb
(Bind Target)
To bind a target (make it persistent), issue the
-pb
command as follows:
-pb < hba_port_inst> < Target ID >
-pbootcode
(Set Primary Boot Target Information)
To set the primary boot code boot target and LUN, issue the
-pbootcode
command as follows:
-pbootcode < hba_port_inst> < tgt > < lun >