Qlogic QConvergeConsole CLI 2400 Series, User Manual

Page: 108 / 366

6–iSCSI Noninteractive Commands
Command Summary
6-2 SN0054667-00 C
The positional parameters vary, depending on the command option specified. For
example, to display an adapter’s configured settings, use the command option
-C
,
followed by the port instance number (positional parameter). In contrast, the
command for providing general information,
-g
, has no positional parameters.
In noninteractive mode, most changes made to the port instance become effective
immediately. This sometimes causes the adapter to reset, as specified in the
command description. Be sure the system is prepared for an adapter reset before
making changes.
This remainder of this chapter contains an alphabetical list of QConvergeConsole
CLI commands used in noninteractive mode.
Command Summary
This section lists and describes each command line option in alphabetic order,
followed by a command description.
-acb
To inquire whether the access method control block (ACB) firmware functions are
supported, issue the
-acb
command. In general, up-to-date firmware and driver
are required for ACB to be supported.
CHAP Name Null-terminated CHAP name, which is sent by the port
instance when responding to the CHAP challenge
CHAP Secret CHAP secret, which is used by the port instance when gener-
ating the CHAP response
Boot Target The target ID of the target device from which to boot
Boot LUN The LUN of the boot device
NOTE:
 The commands are case sensitive. For example,
-g
is not the same as
-G
.
 Only one command line option per input file is valid.

<hba_port_inst>
is an instance number from the list of all iSCSI
adapter ports in the system. You can see this list with the command
-i
.
Table 6-1. Noninteractive Command Variables (Continued)
Variable Definition