22
pLUNGe CUT (FIG. QQ)
NOTE:
Plunge cuts mean to position the tile under
the cutting blade directly and lower the cutting head to
make cuts onto the interior of the tile .
•
using a pencil or marker, mark the area to be cut
on tile.
•
Loosen the blade elevation locking knob (1) to raise
the cutting head upward to the maximum height.
•
Pull the switch upward to turn the tile saw on to
allow the cutting blade at the full speed and wait
until the stream of water from the water nozzle
completely cover the cutting blade.
•
Hold the cutting head firmly by the handle.
•
Move the tile on the cutting table underneath the
cutting blade.
•
Slowly lower the cutting head to make a cut on
the tile. then, raise the cutting head.
•
turn the tile saw off.
•
Withdraw the cutting table from the cutting head and
then adjust the tile position for the next cut.
Fig. QQ
1
Fig. pp
1
2
BeVeL (MITer) CUT (FIG. OO)
•
using a pencil or marker marks the area to be cut
on tile.
•
Loosen the blade elevation locking knob (1) to raise
the cutting head. then, tighten the blade elevation
locking knob.
•
Loosen the blade tilting locking knob (2) to tilt the
cutting head to 22.5° or 45° clockwise. tighten the
blade tilting locking knob.
•
Loosen the blade elevation locking knob (1) to
lower the cutting head in one of the 2 miter slots in
the table. then, tighten the blade elevation locking
knob.
•
Pull the switch upward to turn the tile saw on to
allow the cutting blade at the full speed and wait
until the stream of water from the water nozzle
completely cover the cutting blade.
•
using both hands to slowly push the cutting table
toward the cutting blade to feed the tile into the
cutting blade.
•
turn the tile saw off.
ANGLe CUT (FIG. pp)
•
using a pencil or marker, mark the area to be cut
on tile.
•
Loosen the locking handle (1) to move the rip/angle
guide along the front rail to the desired position and
then tighten the locking handle (1).
•
Loosen the locking knob (2) to turn the guide to the
desired angle along the arc slot and then tighten the
locking knob (2).
•
Pull the switch upward to turn the tile saw on to
allow the cutting blade at the full speed and wait
until the stream of water from the water nozzle
completely cover the cutting blade.
•
using both hands to slowly push the cutting table
toward the cutting blade to feed the tile into the
cutting blade.
•
turn the tile saw off.
Fig. OO
2
1
for 22.5°
bevel cut
for 45°
bevel cut
Summary of Contents for 61900Q
Page 9: ...9 UNPACKING YOUR JOBSITE TILE SAW B C A D E F G H I J K L M N O P ...
Page 25: ...25 PARTS LIST 900 XT PRO TILE SAW 61900Q ...
Page 30: ...30 NOTES ...
Page 31: ...31 NOTES ...
