QEP 61900Q, Owner'S Manual

Page: 13 / 32

13
ASSeMBLING THe MOTOr SUppOrT ArM (FIG. H)
•
install the motor support arm onto base frame. thread
the two bolts (from bag e) into the side holes of the
motor support arm.
•
thread the bolt into the inner hole of the motor support
arm.
•
tighten all three bolts using an 8 mm hex key.
ASSeMBLING THe CUTTING HeAD ASSeMBLY (FIG. I)
•
remove the nut and the washer from the
pivot rod (5)
.
•
attach the cutting head assembly (1) onto the
motor support arm aligning the hole (2) of the motor
support arm (3).
•
Place the washer and the nut on the pivot
rod (5), as shown.
•
tighten the nut by using the provided universal
wrench. then, turn this nut counter-clockwise by
1/2 turn or one turn to adjust the spring torsion.
•
Place the blade elevation locking knob (4) through
the washer and the slot of the motor support arm
(3). tighten the locking knob.
ATTACHING THe CUTTING BLADe (FIG. J, K, L)
•
Loosen the blade cover locking knob (1) and open
the blade cover (2). (fig. J)
Fig. H
Fig. I
1
2
3
5
4
•
Press the arbor lock button (8) on the motor under
the handle, holding it in firmly. (Fig. L)
•
Loosen the arbor bolt (3) and take the arbor bolt and
the outer blade flange (4) off. (Fig. K)
•
Place the blade onto the shaft (5).
•
Make sure the blade fits flush against the inner
flange (6) and the rotation arrow is pointing in the
correct direction.
•
Place the blade wrench on the arbor bolt (3-fig. K).
•
Press the arbor lock button (8) on the motor under
the handle, holding it in firmly while turning the
blade counter-clockwise. When arbor lock engages,
continue to press arbor lock button (8) in while
tightening the arbor bolt securely by turning the
blade wrench clockwise. (fig. L)
•
close the blade cover back its original position and
tighten the blade cover locking knob (1). (fig. J)
INSTALLING THe ANTI-SpLASH GUArDS (FIG. M, N)
rear anti-splash guard (Fig. M)
• attach the rear anti-splash
guard on the rear of the
cutting head assembly.
•
thread the screw (Bag "e")
and tighten it by using the
Phillips screwdriver.
Fig. J
1
Fig. K
3
4
5
6
Fig. L
8
2
Fig. M