QEP 61900Q, Owner'S Manual

Page: 11 / 32

11
ASSeMBLY AND ADJUSTMeNTS
For your safety, never connect plug to power source
receptacle until all assembly and adjustment steps
are complete, and you have read and understood
the safety instructions.
ASSeMBLING THe STAND (FIG. A)
•
unpack all parts, and group them together by type
and size. refer to the parts list (page 8-9) in order to
verify the correct quantities.
•
release the hook (1) from the stop screw (2).
•
Bag "N" Hardware
_
attach the bent leg tube (3) to
the both sides of the stand leg (4) using four screws,
four washers, and four nuts,
as shown.
•
tighten the four nuts (fig. a) with a phillips
screwdriver and a 10 mm wrench.
ASSeMBLING THe WHeeLS (FIG. B)
•
Bag "N" Hardware
_
attach one wheel to the rear
leg using the long hex bolt (1), the two flat washers
(2), the sleeve (3) and the lock nut (4), as shown.
NOTE:
Verify that the side of the wheel that has more
ribs (5) is facing inward toward the stand.
• tighten using the universal wrench for the lock nut
(4) and the attached blade wrench provided for the
bolt (1).
NOTE:
do not overtighten, because doing so will not
allow the wheels to turn.
• repeat the above steps for the other wheel to the
rear leg.
SeTTING Up THe STAND (FIG. C, D, e)
• Lift up the left side of the stand as shown. (fig. c)
• unfold the left side leg set (3) by releasing the
locking levers (2) from slot a to slot B, then rest the
left side of the stand onto the floor.
• release the hook (1) from the stop screw. (fig. c)
• Lift the right side frame of stand slowly upward to
its highest position, (fig. e) the locking knob (4) will
rebound to left automatically to secure the stand.
(fig. d) to properly lock the stand, the red lever
MuSt be secured in the slot on this cover plate.
WARNING
!
3
4
1
2
1
2
3
4
2
5
rear of Stand
1 1 1 1
1
2
3
a
B
c
right Side
SETTING UP
1 1 1 1
Locking handle release direction
4
5
Fig. A
Fig. B
Fig. C
Fig. D
Fig. e