QEP 61900Q, Owner'S Manual

Page: 20 / 32

20
LOCKING THe CUTTING TABLe ASSeMBLY FOr
TrANSpOrTING (FIG. KK)
There are three positive locking position for the
cutting table:
NOTE:
When transporting the tile saw, the cutting table
must be locked into one of the positive stops to prevent
the saw from damage.
•
Loosen the cutting table locking handle (1)
counterclockwise and rotate the cutting table locking
lever (2).
•
Move the cutting table to one of the positive locking
position and lock the table by rotating the table
locking lever (2) clockwise.
NOTE:
the pin of the table locking lever (2) will lock
into a hole at one of the three positive stops (3).
rAISe THe CUTTING HeAD (FIG. HH)
NOTE:
always turn off when raising or pressing down
the cutting head.
•
Loosen the blade elevation locking knob (1).
•
Lift the handle (2) upward to raise the cutting head.
•
When adjusting the cutting head to the desired
height, tighten the blade elevation locking knob (1)
to lock.
NOTE:
When transporting or storing the tile saw, the
cutting head should always be locked in the low position.
TILTING THe CUTTING HeAD (FIG. II)
•
to tilt the blade for bevel cutting, loosen the blade
tilting locking knob (1) behind the motor head.
•
firmly grasp the handle (2) and tilt the cutting head
by turning the handle (2) clockwise.
•
tighten the blade tilting locking knob (1).
•
Please note that there are 2 slots in table that will
accept 22.5º and 45º angles.
USING THe WATer pUMp (FIG. JJ)
•
attach the water tube to the water pump (1) and
insert the pump power cord into the power cord
socket. (See aSSeMBLinG the Water PuMP)
• fill the water pan with 5 gallons of water. the pump
should be submerged.
NOTE:
always place the pump in a clean water souce.
•
Turn saw on. If the water flow need adjusted, use
the flow restrictor (2) on the water tube.
Fig. HH
1
2
1
2
Fig. II
2
1
Fig. JJ
Fig. KK
1
2
3