QEP 61900Q, Owner'S Manual

Page: 16 / 32

16
Adjusting the cutting blade 45° to cutting table (Fig. V)
•
disconnect the saw from the power source.
•
Loosen the blade tilting locking knob (1) and move
the cutting blade to the maximum bevel position,
then tighten the locking knob (1).
•
Place the combination square to the cutting table
surface.
•
if the cutting blade is not 45° to the groove (2), turn
the bolt (3) in or out accordingly by using the 3 mm
hex key.
•
Loosen the blade tilting locking knob (1), move the
cutting blade until it is 45° to the cutting table surface
and tighten the locking knob (1).
•
Make sure that the cutting blade does not touch
either side of the groove (2) in the cutting table by
pushing the table past the cutting blade.
1
3
2
Fig. V
CUTTING BLADe DepTH (FIG. W)
•
Loosen the blade elevation locking knob (1).
•
adjust the cutting head down until the outer rim of
the cutting blade is at least 3/16 in. (5 mm) below
the cutting table surface.
•
While holding the upper arm in that position, tighten
the blade elevation locking knob (1).
•
recheck the cutting blade depth by pushing the
cutting table front to back past the cutting blade
and make sure the cutting blade does not touch the
grooves of the cutting table.
Adjusting the cutting blade depth
the maximum depth travel of the cutting head was set
at the factory. check to make certain that the cutting
head extends to 3/16 in. (5 mm) below the cutting table
surface. if the maximum depth needs readjusting:
•
Loosen the blade elevation locking knob (1).
•
Move the cutting head down until the cutting blade
extends just 3/16 in (5 mm) below the cutting table
surface.
•
Loosen the wingnut (4).
•
turn the locking knob (2) in or out accordingly.
•
Make sure the cutting blade does not touch either
side of the groove (3) in the cutting table by pushing
the table past the cutting blade.
•
tighten the wingnut (4).
•
tighten the blade elevation locking knob (1).
INSerTING AND repLACING THe LASer
BATTerIeS (FIG. X)
•
unplug your tile saw.
Failure to unplug your tool could result in accidental
starting and causing possible serious personal injury.
•
Loosen the screw (1) and open the battery cover (2).
•
insert the two supplied aaa batteries in the case
as per the diagram below. if replacing the batteries,
take out the old batteries and place with new aaa
batteries. dispose of old batteries properly.
•
close the battery cover (2) and tighten the screw (1).
WARNING
!
Fig. X
1
2
Fig. W
1
2
3
4