QEP 61900Q, Owner'S Manual

Page: 14 / 32

14
Side anti-splash guard (Fig. N)
•
attached the side anti-splash guard (1) on the blade
cover.
•
thread two supplied screws (Bag "e") and tighten
them by using the Phillips screwdriver.
INSTALLING THe WATer pAN (FIG. O)
•
Slide the water pan (1) on the right & left tracks
located under the water splash plate (2) in the base
frame. the water pan drain hole should be located
under the blade.
NOTE:
To remove the water pan, first lift up slightly on
the water splash plate (2) then pull out the water pan.
INSTALLING THe SIDe WATer TrAYS (FIG. p)
• attach the side water attachment (1) on the right
of the cutting table assembly, aligning the slot (2)
under the extension wing.
•
align the left side of the side water attachment (3) to
the right side of the side water attachment (1) and
overlap the side water attachment as shown.
Fig. N
1
Fig. O
1
2
INSTALLING THe reAr WATer TrAY (FIG. Q, Q-1)
•
align two slots located on the rear left and right ends
of the base frame with the arms of the rear water
catch tray and gently push in.
NOTE:
Make sure that the arms of two ends of the rear
water catch tray thoroughly pass through the frame
slots.
ASSeMBLING THe WATer pUMp (FIG. r, S)
•
Place the drain plug (1) and water filter (2) in the
water pan (3) as shown. (fig. r)
•
connect the end of the water tube (4) to the nozzle
(6), located on the top of the water pump (5).
•
Place the water pump (5) in the corner of the water
pan, near the water filter. (fig. r)
•
insert the pump power cord (7) into the power cord
socket (8). (fig. S)
Fig. p
1
2
3
front
right Side
Fig. Q
Fig. Q-1