PC200 PVA
Revision G (2019)
22 of 56
5.
Clean the fluid section.
6.
Use a pick to remove large amounts of material. Do not mix the materials.
7.
Use solvent as necessary to clean hard to get to locations.
Figure 28: Clean the Fluid Section
8.
Clean the separation block and manifold. Make sure to clean all grooves and
ports.
9.
Clean the piston-rod assembly.
NOTE: RW-series PC200 uses two different size rods.
10.
Clean the rods.
11.
Use a wrench to hold one rod and a use hex key to loosen the screw that
holds the rod in position in the piston.
12.
Remove both rods. Examine the rods and make sure there is no material on
them. Clean the screws if necessary.
13.
Use the hook and pick set to remove the O-ring on the piston.
14.
Clean the piston and the O-ring.
Figure 29: Clean the Piston-Rod Assembly
Summary of Contents for PC200 Series
Page 41: ...PC200 PVA Revision G 2019 41 of 56 PC200RW Series Mechanical Drawings ...
Page 43: ...PC200 PVA Revision G 2019 43 of 56 How to Order Figure 63 Part Number Configuration ...
Page 45: ...PC200 PVA Revision G 2019 45 of 56 Figure 64 Accessories and Options ...
