PVA Emergence PRO, Operation Manual

Page: 36 / 68

Emergence PRO ™ 3D Printer Manual
Revision C / December 2020
Page 36 of 68
Remove Hot End
After the filament is removed, perform the steps below:
1. Remove the Filament Guide Tube .
2. Remove the white Heater Cartridge Connector in the slot labeled C.
3. Remove the blue Thermistor Connector in the slot labeled D.
4. Release red Hot End Clamp handle on hot end receiver block.
5. Remove the Hot End .
Load Filament
1. On the Printer Control Screen, select Move and press 50 once in Z values to lower
print bed 50 mm.
2. On the Printer Control Screen, set the Active Bed and Hot End Temperature to
the appropriate print temperature for material.
Filament Bed Temperature Hot End Temperature Nozzle
PCTG 95C°C 240°C Brass
FlexyFit ™ 40°C 235°C Brass
PLA 65°C 210°C Brass
Nylon 12 85°C 285°C Stainless Steel
PLA/Carbon Fiber 70°C 210°C Stainless Steel
Figure 37: Temperatures for Installing Filament
3. Slide the appropriate filament onto the filament support roller. The filament roll
should be oriented so the filament will be coming off the top of the roll toward the
front of the machine (Figure 38).
4. Manually push the filament into the filament guide and continue to feed until the
filament reaches the extruder. You will no longer be able to push the filament at this
point.
5. If necessary, adjust the shaft collars on the filament roll support so the filament roll
is centered relative to the filament guide (Figure 39).
6. Loosen the bolts with a 5 mm Allen key. A 10-20 mm gap between the collar and the
side of the roll is sufficient.