Emergence PRO
™
3D Printer Manual
Revision C
/
December 2020
Page 31 of 68
6.
Hover over a point or double click a probe point to view the resulting measured
height and position (Figure 32).
7.
The resulting four z-values should all be /-0.5 mm left to right and front to
back.
Maximum deviations will display the deviation range for the highest and
lowest values for the four points (Figure 32).
8.
If adjustments are needed, re-run the
Quick Level
macro and follow instructions to
level the bed (Section 2.4.2).
Install and Gap Hot End
1.
On Printer Control Screen, select
Move
. The
Move Head
screen will display.
2.
In the Z value field, press 50 twice to lower the bed roughly 100 mm to install the
hot end. A positive move will increase the gap between the hot end and the print
bed.
3.
To confirm the position of the bed, close out of
Move Head
screen and check the
print head position to confirm that Z-position is roughly 100 mm.
Figure 33
: Move Print Bed
Summary of Contents for Emergence PRO
Page 1: ...Emergence PRO 3D Printer Operation Manual Revision C INNOVATION PRECISION EXCELLENCE ...
Page 62: ...Emergence PRO 3D Printer Manual Revision C December 2020 Page 62 of 68 Figure 58 Print Head 1 ...
Page 63: ...Emergence PRO 3D Printer Manual Revision C December 2020 Page 63 of 68 Figure 59 Print Head 2 ...