Emergence PRO
™
3D Printer Manual
Revision C
/
December 2020
Page 18 of 68
M587 Command
The M587 command will be used to send your desired network information to the web
interface’s G
-code console. The M587 command must include three components.
•
S
: Network SSID
o
Must be enclosed in quotation marks
o
Case-sensitive
•
P
: Network Password
o
Must be enclosed in quotation marks
o
Case-sensitive
•
I
: IP address to use when connected to this network (optional).
o
This should be the IP address that you previously reserved
o
If zero is entered or not specified, an IP address will be acquired via DHCP.
▪
This will result in your network hardware assigning the available IP
addressed based on existing devices connected to the network.
The M587 command must be written in the following format:
M587
S
”WIFI_NETWORK_NAME”
P
”PASSWORD”
I
x.xxx.xx.xxx
Example
:
Network SSID
TEST_Network
Network Password
Testing123
IP Address
1.160.10.240
Using the credentials listed above, the M587 command would be as follows:
M587
S
”TEST_Network”
P
”Testing123”
I
1.160.10.240
Summary of Contents for Emergence PRO
Page 1: ...Emergence PRO 3D Printer Operation Manual Revision C INNOVATION PRECISION EXCELLENCE ...
Page 62: ...Emergence PRO 3D Printer Manual Revision C December 2020 Page 62 of 68 Figure 58 Print Head 1 ...
Page 63: ...Emergence PRO 3D Printer Manual Revision C December 2020 Page 63 of 68 Figure 59 Print Head 2 ...