PURSUIT C238, Owner'S Manual

Page: 58 / 118

10-8
Section 10 Operation
C238
cleats. The spring lines keep the boat from
backing into the dock while allowing it to ride
the tide.
Leaving the Dock
Start the engines and let them warm up for
10 to 15 minutes before releasing the lines.
Boats steer from the stern and it is important
you achieve enough clearance at the stern
to maneuver the boat as quickly as possible.
Push the stern off and maneuver to gain
stern clearance quickly. Proceed slowly until
the boat has cleared the dock and other
boats.
Mooring
Approach the mooring buoy heading into the
wind or current. Shift to neutral when you
have just enough headway to reach the
buoy. Position a crew member on the bow to
retrieve the buoy with a boat hook and
secure the line. Keep the engines running,
until the line is secure.
Leaving a Mooring
Start the engines and let them warm up
before releasing the mooring line. The boat
will already be headed into the wind, so
move it forward enough to loosen the line
and untie it. Back the boat away until you
can see the buoy and slowly move away.
Anchoring
Make sure the bitter end of the anchor rode
is attached to the boat before dropping the
anchor. Bring the bow into the wind or cur-
rent and put the engine in neutral. When the
boat comes to a stop, lower the anchor over
the bow. Allow enough rode so that it is at
least 5 to 7 times the depth of the water and
secure the line to a cleat. Use caution to
avoid getting your feet or hands tangled in
the line. Additional scope of 10 times the
depth may be required for storm conditions.
Check landmarks on shore to make sure the
anchor is not dragging. If it is dragging, start
over. It is prudent to use two anchors if you
are anchoring overnight or in rough weather.
Releasing the Anchor
Release the anchor by traversing to the
point where the anchor line becomes verti-
cal. It should release when you pass that
point. If the anchor does not release, stop
the boat directly above the anchor and tie
the line to a cleat as tight as possible. The
up and down movement of the boat will usu-
ally loosen the anchor. Make sure the
anchor is secured and stowed before getting
underway.
10.9 Controls, Steering or
Propulsion System Failure
The engine covers are machinery guards
and must be in place whenever the engines
are running. DO NOT operate the boat with-
out the covers in place unless you are per-
forming a check or maintenance.
If the propulsion, control or steering system
fails while you are operating the boat, bring
both throttles to idle and shift to neutral.
Determine if the boat should be anchored to
prevent the boat from drifting or to hold the
bow into the seas. Investigate and correct
the problem if possible. Make sure the
engines are off before investigating the prob-
!
WARNING
SINKING OR DROWNING HAZARD
Anchoring at the stern can pull a boat
under water. DO NOT anchor at the
stern.
!
WARNING
MOVING PARTS HAZARD
Contact with moving parts can entan-
gle, cut and cause death or serious
injury. DO NOT come close enough to
make contact with any running
machinery moving parts, i.e., engine
or propeller. Contact can result in loss
of body parts, strangulation, burns
and/or severe loss of blood resulting
in serious injury or death.