PURSUIT C238, Owner'S Manual

Page: 26 / 118

4-2
Section 4 Electrical System
C238
Battery Switch Panel
The batteries are controlled with a single
battery switch located in the head. The
switch can be used to turn on the battery
current or parallel the two batteries if
needed.
Battery Switches and Main Breakers
The battery switch can be set to combine the
engine and electronics batteries for emer-
gency starting. In normal operation the
switch should not be set to Combine.
Breakers
The main breakers are located in the battery
switch panel and provide protection for all
DC power. The breakers in the battery panel
are all resettable. If a breaker is tripped for
any reason it can be reset by this simple pro-
cess:
1. Turn the switch that controls the compo-
nent to the off position.
2. If it is a push button breaker, then simply
push in and hold the button for a second.
3. If it is flip type breaker move it to the OFF
position and then back to the ON position.
Helm Main
Supplies the 12-volt current to helm panel.
Electronics Main
This is reserved for electronic accessories
installation. An electronic bus is located
behind the helm.
Stereo Memory - This breaker powers the
stereo to maintain station memories and set-
tings.
Aft Bilge - This breaker powers the aft bilge
pump.
Engine Isolator - This breaker controls the
current coming from the engine isolator. If
this breaker is off there will be no current
reaching the battery.
Spare - Reserved for a spare accessory.
Any accessory device added must not
exceed the amperage of the breaker or total
circuit capacity.
!
CAUTION
DO NOT operate the boat with the
EMERG PARALLEL battery switch in
the ON (combined) batteries position.