PURSUIT 3070 Conter Console, Owner'S Manual

Page: 89 / 126

C 300
89
Chapter 11:
ROUTINE MAINTENANCE
11.1 General
BEFORE USING A CLEANING PRODUCT, REFER TO THE PRODUCT DIRECTIONS AND
SPECIFICATIONS.
IF URETHANE FOAM IS USED IN THE CONSTRUCTION OF YOUR BOAT, USE SPECIAL
CARE WITH HIGH TEMPERATURES OR FLAMES IN THESE AREAS. URETHANE FOAM
CAN IGNITE. REFRAIN FROM BURNING, WELDING, SMOKING, THE USE OF SPACE
HEATERS AND LIGHTS IN AREAS WHERE URETHANE FOAM IS PRESENT. IF IGNITED,
URETHANE FOAM BURNS RAPIDLY, PRODUCES EXTREME HEAT, RELEASES HAZARD-
OUS GASES AND CONSUMES MUCH OXYGEN.
WHEN PAINTING OR CLEANING, VENTILATE THE AREA. PAINT OR CLEANING PROD-
UCTS MAY BE FLAMMABLE AND/OR EXPLOSIVE.
11.2 Exterior Hull and Deck
HULL CLEANING - BELOW THE WATER LINE
When the boat is removed from the water, clean the outer bottom surface immediately. Algae, grass, dirt and
other marine growth is easier to remove while the hull is still wet. Use a pressure cleaner or a hard bristle
brush to clean the surface.
BOTTOM PAINTING
If the boat is to be left in saltwater for extended periods, the hull must be protected from marine growth by
antifouling paint. Because of variations in water temperature, marine growth and pollution in different
regions, your dealer and/or a qualified boat yard in your area should be consulted when deciding what bottom
paint system to apply to your hull. This is extremely important as pollution and marine growth can damage
fiberglass hulls.
SANDING OR SANDBLASTING THE HULL BOTTOM WILL DAMAGE THE FIBERGLASS.
USE ONLY STANDARD ANTIFOULING PAINTS AND FIBERGLASS WAX REMOVERS AND
PRIMERS RECOMMENDED BY THE ANTIFOULING PAINT MANUFACTURER WHEN PRE-
PARING THE HULL FOR BOTTOM PAINT. SANDING OR SANDBLASTING AND THE
USE OF A COATING OTHER THAN STANDARD ANTIFOULING PAINT OR EPOXY BAR-
RIER COATINGS ARE NOT RECOMMENDED AND WILL VOID THE FIVE YEAR HULL
BLISTER WARRANTY.
NOTICE
NOTICE