PURSUIT 3070 Conter Console, Owner'S Manual, Page: 37 / 126

C 300
37
Hardtop Light
Pressing this button activates the light mounted underneath the hardtop.
LOWER PANEL
Port/Starboard Fuel Gauge
The fuel gauge switch allows one fuel gauge to be used for both fuel tanks. With the ignition switch "ON,"
move the switch to the number 1 position and the fuel gauge will show the level in the starboard tank. Move
the switch to the number 2 position and the gauge will show the fuel level in the port tank.
Forward Bilge Pump
Activates the forward bilge pump which is installed in the center bilge below the console. The pump moves
water out through the thru-hull. To start the pump manually, put the switch in the "ON" position.
Aft Bilge Pump
Activates the manual stern bilge pump which is installed in the aft bilge. The pump moves water out
through the thru-hull fitting in the hull. To start the pump, put the switch in the “ON” position.
Note: The bilge is equipped with two bilge pumps. One pump is fully automatic and the other pump
is activated by a switch. The automatic pump will start automatically when there is sufficient water
in the bilge to activate the float switch. The float switch is protected by a circuit breaker located on
the battery switch panel and is always supplied current when the batteries are connected. The manual
pump is activated by the bilge pump switch in the helm switch panel.
Parallel
This switch is not used. See Parallel Switch in the DC Distribution System section of the Electrical System
chapter.
Windlass
This switch controls the optional windlass which is mounted to the deck directly above the rope locker. It
is protected by a circuit breaker, of the type and rating recommended by the windlass manufacturer, that is
located on the battery switch panel.
Accessory Switch
This switch is supplied to protect additional equipment that may be installed. If no accessories are activated
by this switch it remains wired in the panel in reserve.
Horn
Activates the boat horn.
Lower Helm Switch Panel (Typical)