The raw water washdown system must also be drained. To do
so:
1. Open the seacock and the washdown faucet, in the
cockpit, under the starboard covering board.
2. Disconnect the hoses from the intake and outlet sides of
the pump and let the water drain out. Use compressed
air, if necessary, to remove all the water.
Be very careful with compressed air. Too much
pressure or volume can damage the raw water
system.
3. Run the pump for a few seconds to remove all water
from the pump body.
4. Lubricate the pump impeller per instructions in the
pump owners manual.
5. Reconnect all hoses and tighten the clamps securely.
Figure 6-3: Generator Muffler Plug
CAUTION
STORING AND WINTERIZING YOUR BOAT
ENGINE ROOM AND BILGE AREAS
3000 Offshore Express
6-9
Summary of Contents for 3000 OFFSHORE EXPRESS
