When the holding tank (located outboard of the port engine in
the engine room) is full, it is necessary to pump it out. To do
this:
1. Take your boat to a marine facility where a pump out
station is located.
2. Remove the cap from the waste deck fitting, located on
the port side deck, at the aft end of the side windshield
(it has a green cap), with the special wrench provided.
Turn counterclockwise until loose and remove.
3. Insert the pump out hose into the opening.
4. Remove all waste from the holding tank.
5. Fill the tank with clean water and pump out again.
6. Replace the cap and tighten.
7. Open the flushing valve on top of the holding tank
(near the level sender) and flush the sender for 5
seconds. Close the valve.
Rev. B 08/17/98
Macerator Pump
Vent
Pump-Out
Holding Tank
Y-Valve
Head
Overboard Discharge
Seacock
Raw Water
Intake Strainer
Figure 5-9: Head with Macerator Schematic
HEAD SYSTEM
ROUTINE MAINTENANCE
5-16
3000 Offshore Express
Summary of Contents for 3000 OFFSHORE EXPRESS
