PURSUIT 3000 OFFSHORE EXPRESS, Owner'S Manual

Page: 101 / 120

under the cockpit floor should be disconnected from the pumps
and drained. Any bilge water should then be removed with a
sponge and wiped dry.
When reconnecting raw water hoses, be certain to
tighten clamps well. Leaking fittings on raw water
hoses can sink the boat.
6 . 6 . 1 . Engines, Transmissions and Generator
The engines, transmissions, and generator should be prepared
for storage according to the manufacturer’s recommendations.
Please refer to the owner’s manuals for these items for specific
instructions.
6 . 6 . 2 . Exhaust Systems
The exhaust systems for the optional generator must have the
water drained from it’s muffler.
The generator muffler should be drained by removing the plug
from the bottom of the muffler (see Figure 6-3), allowing the
water to drain out, and replacing the plug.
B E C E R TA I N T H AT T H E D R A I N P L U G S A R E
INSTALLED TIGHTLY. FAILURE TO DO SO WILL
ALLOW ENGINE EXHAUST GASES CONTAINING
CARBON MONOXIDE AND WATER INTO THE BILGE
AREA.
6 . 6 . 3 . Raw Water Systems
The engine cooling water systems must be drained by opening
the seacock, opening the strainer, and disconnecting the hoses,
if necessary, to remove all water. Reconnect all hoses and
reassemble the strainer when complete.
CAUTION
WARNING
ENGINE ROOM AND BILGE AREAS STORING AND WINTERIZING YOUR BOAT
6-8 3000 Offshore Express