PURSUIT 2460 Denali, Owner'S Manual

Page: 51 / 132

2460 Denali
6.3 Livewell (Optional)
Sea water is provided to the livewell by a 12-volt circulation
pump. This pump is designed to carry a constant flow of water
to the livewell. The pump is not equipped with a pressure sensor
and is activated by the livewell switch in the 12-volt panel or a
separate switch in the cockpit. An overflow built into the
livewell automatically controls the water level in the livewell.
Always turn the pump off at the switch panel when the livewell
is not in use.
To fill the livewell, insert the plug into the drain fitting at the bottom of the livewell. Make sure the
valve at the intake thru-hull fitting is open and activate the livewell switch. When the water level
reaches the overflow, it will automatically be regulated.
To drain the livewell, turn off the livewell pump and pull out the plug in the drain fitting at the
bottom of the livewell. When the livewell has completely drained, use the washdown hose to flush
the livewell and drain of debris.
The livewell supply thru-hull valve should be closed whenever the livewell is not in use. This will
prevent water from entering the livewell while the boat is cruising.
The livewell system is equipped with a sea strainer on the intake side of the pump located in the
bilge behind the stern access hatch. This should be checked frequently and cleaned as necessary.
Note: Do not use the livewell as a dry storage area when it is not in use. Sea water could
accidently be delivered to the livewell from the thru-hull fitting and damage
equipment stored there.
Livewell
6-3