PURSUIT 2460 Denali, Owner'S Manual

Page: 41 / 132

2460 Denali
Bilge Blower
This switch supplies electrical current to the blower that provides ventilation to the engine
compartment prior to start up and while operating below cruise speed.
Note: Please refer to the DANGER and CAUTION notations in the Ventilation Systems
Chapter.
Bilge Pump
The automatic bilge pump is a special macerator type pump that is equipped with run-dry
protection and a remote pickup. The pickup for this pump is located under the engine . An air-
dome style switch controls the automatic operation and is mounted on the transom. The manual
pump is located forward of the engine and operates independently of the automatic pump.
Note: The bilge pump will start automatically when there is sufficient water in the bilge
to activate the automatic switch. The automatic switch is protected by a circuit
breaker located near the battery selector switch and is always supplied current when
the batteries are connected.
Nav Lights
The switch is a three-position switch. The middle position is “OFF.” Moving the switch in one
direction will activate the navigation lights. Moving the switch in the opposite direction activates
the anchor light.
Cockpit Lights
Activates the lights that illuminate the cockpit area.
Panel Lights
Activates the engine gauge and compass lights.
Wiper
Activates the windshield wipers.
Cabin Lights
Activates the lights in the cuddy cabin.
Livewell Switch
This switch activates the livewell circulating pump that supplies water to the livewell.
Washdown Pump
This switch activates the raw water washdown pump. The pump is the pressure demand type and
is protected by a circuit breaker in the panel and an automatically resetting breaker on the pump
motor.
Note: Please refer to Raw Water system chapter for more information on the livewell and
washdown systems.
4-3