PURSUIT 2460 Denali, Owner'S Manual

Page: 107 / 132

2460 Denali
Bilge
Coat all metal components, wire busses, and connector plugs in the bilge with a protecting oil. It
is also important to protect all strainers, sea cocks, pumps, and steering components.
The bilge pumps and bilge pump lines must be completely free of water and dried out when the boat
is laid-up for the winter in climates where freezing occurs. Compartments in the bilge that will not
drain completely should be pumped out and then sponged until completely free of water.
Dry the hull bilge and self-bailing cockpit troughs. Water freezing in these areas could cause
damage.
Special Notes Prior To Winter Storage
If the boat will be in outside storage, properly support a storage cover and secure it over the boat.
It is best to have a frame built over the boat to support the canvas. It should be a few inches wider
than the boat so the canvas will clear the rails and allow passage of air. If this cover is fastened too
tightly there will be inadequate ventilation and this can lead to mildew, moisture accumulation, etc.
It is essential to fasten the canvas down securely so that the winds cannot remove it or cause chafing
of the hull superstructure. Do not store the boat in a damp storage enclosure. Excessive dampness
can cause electrical problems, corrosion, and excessive mildew.
Whenever possible, do not use the bimini top or convertible top canvas in place of the winter storage
cover. The life of these canvases may be significantly shortened if exposed to harsh weather
elements for long periods.
PLACING AN ELECTRIC OR FUEL BURNING HEATING UNIT IN THE BOAT CAN BE PO-
TENTIALLY HAZARDOUS AND IS NOT RECOMMENDED.
Proper storage is very important to prevent serious damage to the boat. If the boat is to be stored
indoors, make sure the building has enough ventilation. It is very important that there is enough
ventilation both inside the boat and around the boat.
14.3 Recommissioning
DO NOT OPERATE THE BOAT UNLESS IT IS COMPLETELY ASSEMBLED. KEEP ALL
FASTENERS TIGHT. KEEP ADJUSTMENTS ACCORDING TO SPECIFICATIONS.
Note: It is important and recommended that the fitting out procedure for the marine gear
be done by a qualified service person. Read the engine owner’s manual for the rec-
ommended procedure.
14-5