PURSUIT 2460 Denali, Owner'S Manual

Page: 45 / 132

2460 Denali
Chapter 5:
FRESHWATER SYSTEM
5.1 General
The freshwater system consists of a potable water tank, distribution lines and a distribution pump.
The tank is filled through a labeled deck plate located on the side of the center console. An in-line
strainer located near the pump protects the system from debris.
DO NOT FILL SYSTEM WITH ANYTHING OTHER THAN WATER. SHOULD THE SYSTEM
BECOME CONTAMINATED WITH FUEL OR OTHER TOXIC FLUIDS, COMPONENT RE-
PLACEMENT MAY BE NECESSARY.
DO NOT CONFUSE FUEL FILL DECK PLATES WITH THE WATER OR WASTE FILL DECK
PLATES. THESE PLATES ARE ALSO LABELED ACCORDINGLY. IF GASOLINE OR DIE-
SEL FUEL IS ACCIDENTALLY PUMPED INTO THE WATER OR WASTE TANK, DO NOT
ATTEMPT TO PUMP IT OUT YOURSELF. WATER AND WASTE PUMPS ARE NOT DE-
SIGNED TO PUMP FUEL AND A FIRE OR EXPLOSION COULD RESULT. CONTACT YOUR
DEALER OR THE PURSUIT CUSTOMER RELATIONS DEPARTMENT FOR ASSISTANCE IN
HAVING THE FUEL PROFESSIONALLY REMOVED AND COMPONENTS OF THE FRESH-
WATER SYSTEM REPLACED AS NECESSARY.
5.2 Freshwater System Operation
Fill the water supply tank slowly through the labeled deck plate.
After filling the water tank, partially open the faucet. The freshwater switch
on the 12-volt panel should be on. Allow the pump to run until all of the
air is purged from the system and a steady stream of water is flowing from
the outlet. Next, turn off the faucet. As the pressure builds the pump will
automatically shut off.
When properly primed and activated the water system will operate much
like the water system in a home. An automatic pressure sensor keeps the
system pressurized. If the system has been recently filled or has not been
used for an extended period, air bubbles may accumulate at the pump and
the system may have to be re-primed. Whenever the boat is left unattended,
the freshwater pump switch should be placed in the “OFF” position.
5-1
Freshwater Pump