PURSUIT 2460 Denali, Owner'S Manual

Page: 105 / 132

2460 Denali
• The cradle or lift must be in the proper fore and aft position to properly support the hull. When
the cradle is in the correct location, the bunks should match the bottom of hull and should not
be putting pressure on the lifting strakes.
BOATS HAVE BEEN DAMAGED BY TRAILERS, LIFTS AND CRADLES THAT
DON’T PROPERLY SUPPORT THE HULL. ALWAYS MAKE SURE THE
BUNKS AND ROLLERS ARE ADJUSTED SO THEY ARE NOT PUTTING
PRESSURE ON THE LIFTING STRAKES AND ARE PROVIDING ENOUGH
SUPPORT FOR THE HULL. HULL DAMAGE RESULTING FROM IM-
PROPER CRADLE OR TRAILER SUPPORT IS NOT COVERED BY THE
DENALI WARRANTY.
Preparing The Boat For Storage
• Pump out the head. Flush the holding tank using clean soap, water and a deodorizer. Pump out
the cleaning solution.
• Remove the bilge drain plug, if installed.
• Thoroughly wash the fiberglass exterior, especially the antifouling portion of the bottom.
Remove as much marine growth as possible. Lightly wax the exterior fiberglass components.
• Remove all oxidation from the exterior hardware, and apply a light film of moisture-displacing
lubricant.
• Remove the propeller(s) and grease the propeller shaft using light waterproof grease.
• Remove the batteries and store in a cool place. Clean using clear, clean water. Be sure the
batteries have sufficient water and clean terminals. Keep the batteries charged and safe from
freezing throughout the storage period.
• Refer to the Electrical System chapter, for information on the maintenance of the DC electrical
systems.
• Coat all faucets and exposed electrical components in the cockpit with a protecting oil.
• Clean out, totally drain and completely dry the fishboxes and livewells.
• Clean the exterior upholstery with a good vinyl cleaner and dry thoroughly.
• Remove as many cushions and open as many locker doors as possible. Leaving as many of
these areas open as possible will improve the boat’s ventilation during the storage period.
14-3
NOTICE