PURSUIT 2460 Denali, Owner'S Manual

Page: 26 / 132

2460 Denali
2.3 Neutral Safety Switch
Every control system has a neutral safety switch incorporated into it. This device prohibits the
engine from being started while the shift lever is in any position other than the neutral position. If
the engine will not start, slight movement of the shift lever may be necessary to locate the neutral
position and disengage the safety cutout switch. Control or cable adjustments may be required to
correct this condition should it persist. See your Pursuit dealer for necessary control and cable
adjustments.
The neutral safety switch should be tested periodically to ensure that it is operating properly. To
test the neutral safety switch, make sure the outdrive is tilted down and move the shift lever to the
forward position. Make sure the control lever is not advanced past the idle position. Turn the
ignition key to the start position just long enough to briefly engage the starter for the engine. Do
not hold the key in the start position long enough to start the engine. The starter should not
engage. Repeat this test with the shift lever in reverse and the engine throttle at idle. Again, the
starter should not engage. If the starter engages with the shift control in any position other than the
neutral position, then the neutral safety switch is not functioning properly and you should contact
your dealer and have the neutral safety switch repaired before using your boat. If the engine starts
in gear during this test, immediately move the control lever to the neutral position. Turn the engine
off and have the problem corrected by a qualified marine mechanic before using the boat.
IN SOME SITUATIONS, IT MAY BE POSSIBLE TO ACCIDENTALLY START THE ENGINE
IN GEAR WITH THE THROTTLE ABOVE IDLE IF THE NEUTRAL SAFETY SWITCH IS NOT
OPERATING PROPERLY. THIS WOULD CAUSE THE BOAT TO ACCELERATE UNEXPECT-
EDLY IN FORWARD OR REVERSE AND COULD RESULT IN LOSS OF CONTROL, DAM-
AGE TO THE BOAT, OR INJURY TO PASSENGERS. ALWAYS TEST THE NEUTRAL
SAFETY SWITCH PERIODICALLY AND CORRECT ANY PROBLEMS BEFORE USING THE
BOAT.
2.4 Engine Stop Switch
Your Denali is equipped with a engine stop switch and lanyard. When the lanyard is pulled it will
engage the switch and shut off the engine. We strongly recommend that the lanyard be attached
to the driver whenever the engine is running. If the engine will not start, it could be because the
lanyard is not properly inserted into the engine stop switch. Always make sure the lanyard is
properly attached to the engine stop switch before attempting to start the engine.
Please refer to the engine owner's manual for additional information on the engine stop switch.
2-2