2.1 Vertical Orientation Setup
Vertical Orientation Setup
Warning:
HEAVY EQUIPMENT! Two people
recommended for setting up the press vertically or
horizontally.
1.
The vertical orientation requires the two triangular
shaped legs. To change to the vertical orientation from
the default horizontal orientation, carefully bring the two
front legs off the edge of a table while ensuring the press
will not fall forward.
(Figure 1A)
2.
Using a ¼” Allen wrench or bit, remove the (qty4)
screws securing the horizontal legs as well as the (qty2)
adjacent screws just above them. Remove legs on both
sides.
(Figure 2A)
3.
Line up each vertical triangular leg to the three blank
holes on the side of the frame and then replace the (qty
3) screws on each side.
(Figure 3A)
4.
Then, fasten leveling feet into place, and lift the press
into the full upright vertical orientation.
5.
Place the touchscreen display enclosure to the recessed
position so it is flush with the front of the press.
Figure 2A
Figure 1A
Figure 3A
Vertically Oriented Pikes Peak