2.4 Horizontal Dual Pressure Installation
Hooking Up Your Dual Pressure
Regulators
Horizontal orientation installation detailed below
1.
Unscrew the black collar nuts (qty2) atop each regulator and
remove the aluminum mounting bracket. Using the short
screws (qty2), attach the bracket to your press.
(
Figure 1A)
.
Tighten them with your Phillips screwdriver. For horizontal
setup, simply install the bracket perpendicular to this so that
the regulators are always vertically oriented.
2.
Take your Dual Pressure regulators and re-insert both
through the mounting bracket. Then, re-screw on your black
regulator collar nuts onto both sides so they are hand tight.
(
Figure 2A)
3.
Next, using the long screws (qty3) provided, attach your
Dual Pressure toggle switch and tighten each screw.
(
Figure 3A)
4.
Attach your short pneumatic hose from the toggle switch to
the push connect fitting on the press, and then attach the
pneumatic hoses from the Dual Pressure regulators to the
toggle switch.
5.
In the horizontal orientation, your pneumatic tubing from the
Dual Pressure regulators should not cross and all push
fittings should be firmly seated. (
Figure 4A)
Note:
Your Dual Pressure system installs
easily in both the horizontal and vertical
orientations with just a Phillips screwdriver.
There is a separate bag included in your press
kit with additional pneumatic tubing for the
horizontal setup.
Figure 1A
Figure 2A
Figure 3A
Figure 4A
