2.3 Vertical Dual Pressure
Installation
Hooking Up Your Dual Pressure Regulators
Vertical orientation installation detailed below
1.
Unscrew the black collar nuts (qty2) atop each regulator and
remove the aluminum mounting bracket. Using the short screws
(qty2), attach the bracket to your press.
(
Figure 1A)
.
Tighten
them with your Phillips screwdriver. For horizontal setup, simply
install the bracket perpendicular to this so that the regulators are
always vertically oriented.
2.
Take your Dual Pressure regulators and re-insert both through
the mounting bracket. Then, re-screw on your black regulator
collar nuts onto both sides so they are hand tight.
(
Figure 2A)
3.
Next, using the long screws (qty3) provided, attach your Dual
Pressure toggle switch and tighten each screw.
(
Figure 3A)
4.
Attach your short pneumatic hose from the toggle switch to the
push connect fitting on the press, and then attach the pneumatic
hoses from the Dual Pressure regulators to the toggle switch.
(Figure 4A)
5.
In the vertical orientation, your pneumatic tubing from the Dual
Pressure regulators should cross and all push fittings should be
firmly seated.
Note:
Your Dual Pressure system installs
easily in both the horizontal and vertical
orientations with just a Phillips screwdriver.
There is a separate bag included in your
press kit with additional pneumatic tubing for
the horizontal setup..
Figure 1A
Figure 2A
Figure 3A
Figure 4A
