2.2 Horizontal Orientation Setup
Horizontal Orientation Setup
Warning:
HEAVY EQUIPMENT. Two people
recommended for setting up the press vertically or
horizontally.
1.
The horizontal orientation requires the two short
rectangular legs. To change to the horizontal orientation
from the vertical orientation, first lean the press slightly
forward and have a friend unscrew the leveling feet.
Then, re-screw two of the leveling feet into the two
holes on back of the press, near the top.
2.
Next, carefully lay the press on its back and using a ¼”
Allen wrench or bit, remove the (qty6) screws securing
the vertical legs.
(Figure 1A)
3.
Line up each horizontal rectangular leg to the two blank
holes on the side of the frame and then replace the (qty
2) screws on each side.
(Figure 2A)
. Put the additional
remaining screw in the empty holes on each side.
4.
Then, fasten leveling feet (qty2) on the bottom screw
hole ports of the horizontal rectangular legs.
(Figure
3A)
5.
Slide your press back so it sits securely on your table
for operation.
Figure 1A
Horizontally Oriented Pikes Peak
Figure 2A
Figure 3A
