CONNECTING THE AUDIO OUTPUTS
11. If you wish to use the Audio outputs, please connect cables to the relevant output - each output zone
features Analogue, Optical and Digital Coax options.
Note: The audio outputs allow matrixing, please refer to Web Interface Setup to find out more.
CONNECTING TO NETWORK
12. Connect a standard Ethernet cable (Category 5e/6/7) from the matrix's 'Ethernet' port to your router
or network switch. Crossover cables are not supported.
Note: Network connection is required for supporting full control/remote monitoring features of the
product.
TURNING ON THE MATRIX
13. Insert the supplied power cord and plug into the AC mains.
14. Turn ON the power switch.
15. As it powers ON, the front panel LEDs (System Health, Network, Cloud) will illuminate momentarily
before it begins its initialisation sequence.
Note: The initialisation process takes between 20 seconds and up to 2 minutes. However, it is possible
that a firmware update may be available the first time the unit is powered ON - in this instance the matrix
may take longer to initialize. If both the System Health and Network LEDs flash (orange/green) quickly
together then a firmware update is being applied. Please wait and do not disconnect the power until this
update has completed.
