VI. RUNNING A TEST, continued
How to Run a Reflectance Test
1.
Insert correct MEMo Chip for the lot of strips in use.
2.
Insert MEMo Chip with finger notch (top) side up, lot number code facing
down.
3.
Press either button to turn on the analyzer.
4.
When INSERT STRIP is displayed, insert the test strip into the analyzer
as far as it will go.
5.
Obtain a blood drop following the correct technique. (If venous blood is
used, collect in an EDTA or heparin tube. Invert gently 5-7 times to mix
completely. Immediately collect sample with glass capillary tube and
dispense correct volume as specified in test strip instructions for use
(package insert) onto test strip.)
6.
When APPLY SAMPLE is displayed, apply blood to the test strip. Refer
to each specific test strip package insert for sample volume and sample
application instructions.
7.
Within one to two minutes, the results will be displayed.
8.
Remove test strip and discard.
9.
The analyzer automatically shuts down after three minutes of idle time
with no test strip inserted.
How to Run an Electrochemical Test
1.
Insert the MEMo Chip that matches the lot number on the test strip vial.
2.
Press either button to turn on the analyzer.
3.
Remove a single electrochemical test strip from the test strip vial and
immediately replace the cap.
4.
Insert the electrochemical test strip into the designated electrochemical
test strip port.
5.
APPLY SAMPLE icon appears on the display.
6.
Obtain a blood drop following the correct technique. (If venous blood is
used, collect in an EDTA or heparin tube. Invert gently 5-7 times to mix
completely. Immediately collect sample with capillary tube, dispense large
drop and touch drop to end of test strip.)
7.
Gently hold finger to the tip of the electrochemical test strip to apply a
drop of blood. Do not place blood on top of the test strip. Do not press
the test strip into the finger.
8.
Blood will be drawn into the strip automatically by capillary action.
9.
TESTING will appear until the result is displayed.
32
