PTI security systems VP keypad controls entry, Installation And Operation Manual

Page: 22 / 40

18 19
At this point, the basic parameters required for operation have been entered.
If no other options are active or required, you can exit the setup mode.
Following are optional parameters to customize the feel of the site.
Setup Password
* =Change #=No
Allows you to change the setup password from the
factory default of 8898. When YES is selected, the unit
will prompt for the new password. The new password
must be entered twice for verification before it will
be changed. If both passwords entered match, the
password will be changed. Otherwise, a message will
indicate that the passwords do not match.
Tamper Switch:
Disabled
Controls the use of the tamper sensor. If enabled, the
keypad will not function and an alarm will occur from the
controller if the unit is tampered with. Factory default is
Enabled.
Secure Entry
Disabled
Controls the characters displayed during code entry.
When set to Enabled, the display will show only an X for
each key pressed. When set to Disabled, the numbers
pressed will be echoed to the display. Factory default is
Disabled.
Beep with Key
Enabled
Controls the internal buzzer used to provide audio
feedback for any key press. When set to Enabled, the
buzzer will produce a short beep when a key is pressed.
When set to Disabled, the buzzer will not sound with key
presses. Factory default is Enabled.
Beep with Access
Enabled
Causes the internal buzzer to sound when an access is
granted. A valid access will cause the buzzer to sound
one long beep. All other attempts will cause the buzzer
to sound four short beeps. Factory default is Enabled.
Beep with Alarm
Disabled
Controls the internal buzzer used to provide audible
feedback when a system alarm occurs. When set to
Enabled, the internal buzzer will sound whenever an
alarm occurs and remain on until the alarm resets from
the controller. When set to Disabled, the internal alarm
buzzer will not sound with an alarm event. Factory
default is Disabled.
Language XX.XX
English
Allows user messages to be displayed in one of
seven languages. The other languages are French,
Spanish, Italian, Deutsch (German), Danish, Dutch,
and Norwegian. This affects the user messages and the
setup functions. The XX.XX denotes the revision of the
language firmware. Factory default is English.
Date Format
US
Controls how the date is displayed on the screen. Options
are US and European. US format displays MM/DD/YY.
European displays DD/MM/YY. Factory default is US.