PTI security systems VP keypad controls entry, Installation And Operation Manual

Page: 10 / 40

7
6
Mounting Access Devices
The proper mounting height for the VP varies with the application. There
are several options for mounting access devices: surface mount and wall
mount. These can be attached to a wall or installed at an entrance using
a gooseneck or bollard.
Once it has been determined where to install the keypad, the location and
purpose of the device should be noted on a site security wiring plan that is
kept in a safe location for future maintenance and service purposes.
Surface Mount
Surface mounting of keypads is
generally used in conjunction with door
strikes and elevators. Mounting height
is generally 48” – 58” from the finished
floor to the center of the ‘5’ button on
the touchpad. The actual location of
the keypad may be affected by local
building codes.
The type of fasteners required will
depend on the material used to
construct the wall. If the VP is installed
on an exterior wall, make sure the
contact point between the housing and
the wall is sealed with some form of
silicone sealant rated for outdoor use
to prevent moisture and insects from
getting into the housing.
Gooseneck Stand Mount
A gooseneck is commonly used for driveways for vehicle access. The
gooseneck can also be used near doors for wheelchair access or when
sidewalks and landscaping require a freestanding keypad mount away
from the building
.
The base plate is equipped with a hole that will accept conduit (¾”
maximum) for the electrical wiring . Ensure the conduit is placed properly
and the wiring is run through the conduit before mounting the gooseneck
stand to the concrete base. The actual location of the gooseneck and the
mounting techniques may be affected by local building codes. Generally,
the keypad should be protected with concrete bollards that prevent
vehicles from hitting the keypad.
There are several different styles of gooseneck stands available. See
Figure 6 for the dimensions of two common styles.
Figure 6