5. LCD assembly & Electronics
Original Prusa MINI+ kit assembly
91
STEP 8
Mounting the power switch
Guide the power cables through the square hole in the MINI-Z-bottom like in the
picture.
Make sure the OFF "o" symbol is on the right.
Push the power switch evenly with your thumbs to the MINI-Z-bottom.
STEP 9
Connecting the power switch
Connect both power cables to the pins on the Buddy board. The order of cable
connections, polarity and orientation doesn't matter.
Make sure the connectors are fully connected.
The gap between the connectors
and the Buddy board should be approximately 1-2 mm.
Make sure the connectors are not loose and do not wobble.
This can cause fatal
destruction of the electronics.
Carefully push the cables down so that they don't protrude from the MINI-Z-
bottom.
Summary of Contents for Original Prusa MINI
