3. X-axis & Extruder assembly
62
Original Prusa MINI+ kit assembly
STEP 29
Connecting the X-axis motor
Connect the X-axis motor cable to the Buddy control board. Use the second slot
from the left.
STEP 30
X-axis belt tensioning
Move the X-carriage all the way to the Z-carriage.
Using a finger on your left hand push the belt down in the center of the X-axis.
Some force should be needed for bending the belt, BUT don't try to overstretch the
belt as you might damage the printer.
Adjust it by releasing or tightening both screws on the X-end.
Release the screws
, bring the X-end closer to rods and thus decrease the
overall tension.
Tighten the screws
, X-end will move apart, the overall tension will increase.
Summary of Contents for Original Prusa MINI
