23
The LED on the back panel, shown in Figure 6 below, performs the following
function:
G
The green Link LED, located to the left of the 10Base-T ports,
lights up when a physical connection exists between the Cordless
Gateway and an attached Ethernet device. The LED will not light
up if a damaged or improper 10Base-T cable is attached.
The Cordless Gateway has several ports and buttons on its back panel, as
shown in Figure 6. Each port and button is described below:
G
10Base-T Port I: This port is wired like a standard NIC (network
interface card). Use a standard 10Base-T cable to connect Port I to
an Ethernet hub or to device wired like an Ethernet hub, such as a
cable modem or DSL modem.
G
10Base-T Port II: This port is wired like an Ethernet hub. Use a
standard 10Base-T cable to connect Port II to a stand-alone PC or to
a device wired like an Ethernet NIC (network interface card).
Note:
Use either 10Base-T Port I or 10Base-T Port II. You cannot use
the two 10Base-T ports simultaneously.
G
Teach button: When this button is pressed, the Cordless Gateway
will send out a notification that allows other Symphony products
that are operating in learn mode to join the cordless network.
G
Learn button: When this button is pressed, the Cordless Gateway
will enter learn mode to listen for network information from another
Symphony product that is operating in teach mode.
Note:
Do not press either the Teach or Learn button unless directed to
do so by the Symphony Composer Installation Wizard or by a
Symphony Technical Support representative.
