133
Problem/Symptom
Question
Possible Solution/Answer
Chapter in
User's Manual
Which 10BaseT port
should I use to connect the
Cordless Gateway to a
cable modem?
In general, a 10BaseT port on an
ISDN router, a cable modem, or
DSL modem will have a pinout
similar to a cabling hub. In this
case, connect an Ethernet cable to
the Cordless Gateway's 10Base-T
Port I. However, if the 10Base-T
Link LED does not illuminate on
the Cordless Gateway and on the
attached device, try connecting the
cable to 10Base-T Port II.
3
The Link LED on the back
of the Cordless Gateway is
not illuminated.
Try connecting the cable to both
ports on the Cordless Gateway in
succession. If the Link LED does
not light up when the cable is
connected to either port, try
another Ethernet cable; your cable
may be damaged.
3
The Cordless Gateway's
Power Indicator LED is
blinking on and off.
The Cordless Gateway is in the
middle of upgrading its firmware;
be patient while it completes the
upgrade process.
3, 10
The Cordless Gateway
Networking icon in the
Windows System Tray is
red. Why?
The Cordless Gateway icon will
turn red when the computer cannot
communicate with the Cordless
Gateway or when the Cordless
Gateway is in Upgrade mode and
waiting to receive a new version of
the firmware. Try these steps:
1. Confirm that the Cordless
Gateway is powered on.
2. You may be out of range of the
Cordless Gateway. Try moving the
computer closer to it.
3. Confirm that the Security Code
has not been changed for the
Symphony-HRF or Symphony
Adapter within the Maestro
Configuration Tool.
6, 10
