Installation
24
4.
Align one of the #6 wood screws with one of the mounting holes (see Figure 6)
and screw it into one of the wall anchors or directly into the wall. Do not tighten.
5.
Insert the second screw into the remaining mounting hole and screw it into the
remaining wall anchor or directly into the wall.
6.
Tighten the two screws to secure the mounting disk to the wall.
7.
Attach the Access Point to the mounting disk by aligning the Access Point’s
mounting holes (located on the underside of the unit) over the mounting disk’s
raised notches (see Figure 6).
8.
Slide the Access Point over the mounting disk until it locks into place.
9.
Wall mounting is now complete. Return the instructions on page 20 to install the
Access Point cabling.
