EPA
Response
Start / Idle up
DBA
Circuit mode
Servo speed
ABS
SST
St right 100%
left 100%
Th forw 100%
brake 100%
[ EPA ]
Circuit Mode Functions
Circuit Mode contains the most commonly used programming features that you'll
likely be changing on the circuit. Circuit Mode programming is laid out in 3
programming levels (Basic, Intermediate, and Advanced) that are accessed based on
user's capability and the kind of functions requested for various surface models and
for the racing conditions. Please refer to the programming map on page 14 for the
list of functions available under each programming level.
The Circuit Mode menu is accessed as below
1. Press button at normal display
2. Press button for displaying Circuit Mode menu.
End Point Adjustment (EPA)
[Available in Basic, Intermediate & Advanced Level]
End Point Adjustment, also referred to as travel adjust or travel volume, allows the
precise adjustment of maximum servo throws in either direction of the Steering and
the Throttle. The maximum right/left steering and forward/brake position are set
all independently. Remember, Dual Rate values are tied to the EPA setting for
Steering servo.
Note
Be sure that steering and throttle operation does not apply excessive force to the servo
horn. Excessive force applied to the servo horn may result in damage to the servo and loss
of control.
1. Press button to display EPA screen.
2. Press / button until desired EPA value appears on steering right.
3. Press button to set or button to cancel and retain previous setting.
4. Press and repeat steps 2 & 3 to make any EPA adjustments for Steering left,
Throttle forward and brake.
5. Pressing button returns to the Circuit Mode menu.
23
Data Setting & Programming
