QUICK START UP GUIDE
Before playing with your new RAIL™ paintball marker there are a few
important steps to take.
STEP 1. BATTERY INSTALLATION
A. Remove three right hand side grip panel screws with a 3/32” allen key.
B. Open grip panel and install 9V battery into the connector inside the frame. Start
by inserting the top of the battery into the recess and aligning the battery terminals
with the contacts on the board, then pushing the bottom of the battery fully into
place. Ensure that the battery removal ribbon leaves a small tail accessible from
under battery when installed to aid for easy battery removal. Note the markings
above the battery housing which indicate which of the board contacts are positive
and negative and install the battery accordingly.
C. Close grip panel and tighten the three screws back. While closing the panel
observe that no wires get caught between the frame and the grip panel.
STEP 2. BARREL INSTALLATION
A. Screw on the barrel to the front of the RAIL™. Make sure it threads all the
way in and is secure.
B. Attach the barrel plug so that it covers the tip of the barrel and secure
the gun.
STEP 3. LOADER INSTALLATION
Tighten your loader into the adjustable feedneck using a 5/32” Allen key.
For best performance, use a force feeding motorized loader,
preferably the Rotor™ Loader.
QUICK REFERENCE
USING YOUR MARKER
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
4
