ANTI CHOP EYES
The Anti Chop Eye (ACE) system will
prevent the RAIL™ from chopping paint
by not allowing the marker to fire until
a ball is fully seated in front of the bolt.
The eyes use a beam across the
breech. On one side there is a
transmitter, and on the opposite side a
receiver. In order for the marker to fire
with the eyes turned on, the signal
between the two eyes must be broken.
After every shot, before the next ball
drops in the breech, the eye
transmitter and receiver must see each
other. If the eyes are dirty and cannot
see each other between shots, the LED
on the board will start blinking green.
This means that the eyes are dirty. This is an extremely reliable system as long as the eyes are
kept clean. The most common reason for dirty eyes is broken paint. If the eyes become dirty, the
marker will default to a reduced rate of fire to prevent chopping. If this happens during game play,
you can bypass this by turning the eyes off. Clean the eyes as soon as possible.
NOTE: IF THE BATTERY IS LOW, THE MARKER MAY ACT AS IF THE EYES ARE DIRTY OR NOT
FIRE AT ALL. IN THIS CASE, REPLACE THE BATTERY.
SELF CLEANING EYE FEATURE
The RAIL™ is equipped with a self-cleaning eye feature. There is a clear polycarbonate sleeve
mounted inside the breech of the gun covering the eyes. When the bolt tip O-ring passes
through the Eye Pipe, it sweeps off any dirt, grease or paint that could be blocking the
eyes. Normally it is enough to just fire the RAIL™ to clean anything blocking the eyes.
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
22
ANTI CHOP EYES/ BALL DETENTS
MAINTENANCE AND CHANGING
