TROUBLE SHOOTING GUIDE
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
#020 O-rings located outside of the Can.
Lube well before re-inserting bolt kit.
PROBLEMS WITH ELECTRONICS
RAIL™ WON’T TURN ON
• Make sure battery is new and well charged.
• Check that battery is making contact with the
board terminals inside the RAIL™ .
• Make sure there is no dirt or debris blocking
the button from being pressed.
RAIL™ WILL TURN ON / OFF BY ITSELF OR THE
EYES WILL TURN ON / OFF BY THEM SELVES
• Both of these problems are caused because
the button(s) are pressed all the time.
• Remove board from the frame by removing the
grip panel on the left hand side, disconnecting
the cables and pulling the board out. Carefully
remove the two buttons and clean them well.
• Re-assemble and test. If problems persist,
contact authorized service center for board
replacement.
EYES WILL NOT WORK, LED KEEPS
BLINKING GREEN
• First change the battery. The eyes are normally
the first thing to stop working when a battery
is dying.
• Next try to clean the eyes. See page 22
for details on how to remove the Eye Pipe and
clean the eyes.
To test if the eyes work make sure there
is nothing inside the breech and that the bolt is
in the back position. Turn on the RAIL™, the
light should be red after the boot up sequence.
If it is, the eyes are working.
• Check that the eye wire is properly connected
to the board.
• If nothing above helps contact a store or DYE
Precision for eye replacement.
SOLENOID WILL NOT ACTIVATE / TRIGGER
NOT WORKING
• Check that the trigger adjustment is not set so
that the micro switch cannot activate.
You should hear a small click when pulling
the trigger.
• If the RAIL™ fires once when turned on but not
after that your trigger is set so that the micro
switch is always activated. Re-adjust the trigger.
• Change the battery if you are not positive
about it’s charge.
• Check that the solenoid and capacitor cables
are attached to the board and to the right
connectors (solenoid should be attached to
the connector that is colored blue).
TRIGGER BOUNCE / RAIL™ SHOOTING MORE
THAN ONE BALL PER PULL IN SEMI AUTOMATIC
MODE
• Raise the trigger sensitivity level in the
configuration mode.
• Check that the trigger is not adjusted too short.
26
