RAIL
™
BOARD
SETTINGS AND FUNCTIONS
CONFIGURATION MODE
- The following settings can only be
modified in configuration mode. To activate the configuration
mode, turn your marker off and set DIP switch 2 to the ON
position. Next, turn your marker on. The LED's cycle through
all colors for one second to indicate that you have entered
the configuration mode.
To cycle through different settings, pull and release the trigger.
Configuration mode has 4 settings that can be changed.
TO CHANGE A VALUE OF A SETTING
1. While in the configuration mode, choose the setting you wish to change by pulling the trigger
to cycle through different options.
2. When the LED indicates the color of the setting you wish to change, pull and hold the trigger
until the LED starts to flash.
3. The LED will flash as many times as the previous setting was and it will then turn off. Now pull
the trigger as many times as you wish the new setting to be. Note: You must enter a value at this
point, if you do not wish to alter the setting then re-enter the previous value.
4. When done, the LED will cycle through all the colors again to indicate setting was saved and
turn back to green. You can now change another setting or quit the configuration mode.
5. To exit configuration mode, set DIP 2 to the off position.
NORMAL
MODE
CONFIGURATION
MODE
• The RAIL™ is not water resistant. Excess moisture can cause damage
to electronic parts.
• Keep the board and all electrical components clean of dirt, paint and moisture.
• To clean the board, use canned air. If a more aggressive cleaning method
is needed, lightly scrub the components with a soft, dry brush.
Heavy scrubbing will damage the board.
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
9
